|
Sat, Aug 20, 11 at 11:33
| Hi all new member here.
I have a Craftsman Model #13953954 - Garage door opener and I was hoping some one could tell me how to properly wire the doorbell switch on the wall to my unit. Thank you, Biff |
Follow-Up Postings:
|
- Posted by ronnatalie (My Page) on Sat, Aug 20, 11 at 13:34
| Try the garage door forum. Most likely there are two screws on the opener that the button gets directly connected to. |
|
| Connect to the two terminal screws on the back of the door control by color; white to #2, red/white to #1. Connect the bell wire to the two terminal screws on the motor control unit; white to #2, red/white to #1. You can find the manual at the link below. (The doorbell wiring is on page 18). |
Here is a link that might be useful: CRAFTSMAN Garage Door Opener
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Electrical Wiring Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.