Return to the Electrical Wiring Forum | Post a Follow-Up

 o
Panel wiring - neutrals connected to ground bar?

Posted by ntruro (My Page) on
Thu, Jul 8, 10 at 12:01

When I opened the electrical panel in a house we recently purchased, I was surprised to find the following. For all of the circuits, the neutral wires and their respective ground wires are attached together to the ground bar. And the neutral bar is empty.

The house was built in 1963. The cable is cloth covered Romex with ground. In 2005, the previous owner increased the service to 400 Amps and installed two Siemens panels (200 Amps each) and new Siemens breaker switches. One of the panels feeds a 100 Amp subpanel located in the garage. Outside of the house, a new panel and two master breaker switches (one breaker for each of the two 200 Amp panels) were also installed with a new meter. Ground wires run from the outside master breaker panel to a rod directly below it in the ground and a second wire runs inside and connects to the water supply line. The water supply line transitions from copper to PVC inside the basement, near the point of entry to the house - PVC runs to the street.

Questions:
Why arent the neutrals attached to the neutral bar? (Are the two inside 200 Amp panels effectively subpanels to the one outside master panel?)
Is connecting the ground wire to the copper water line correct given that the pipe transitions to PVC before heading outside to the street (the supply line is PVC)?

TIA


Follow-Up Postings:

 o
RE: Panel wiring - neutrals connected to ground bar?

At the main disconnect (typically the main panel), ground and neutral are bonded together and using the same bar for neutrals and grounds is permissible. In other places, the grounds and neutrals must be kept separate all the way back to the main disconnect. You need a neutral bar isolated from the grounds.

What you describe would be fine if this were the main panel. However, it seems like the main disconnect is not either of the Siemens panels are subpanels. You are right, the neutrals should be on their own bar electrically isolated in that panel from the ground.

As for the pipe, if the interior piping is copper (regardless of the external connections), it needs to be bonded. This isn't providing an additional ground (like connecting to the incoming metallic pipe would), but providing safety in case some live wire should come in contact with the interior piping that would engergize all your faucets ,etc...


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Electrical Wiring Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here