Return to the Electrical Wiring Forum | Post a Follow-Up

LED Light Circuit

Posted by jtaeko (My Page) on
Sat, Jul 20, 13 at 1:29

Hi, I know this is a specialized post but was wondering if someone here could answer. It's pretty basic.

I want to make a DC (battery) powered circuit of 2 LEDs in parallel. The space for the battery is very limited. So I was thinking about using a 9v battery (a 1.5v won't last as long). But the LEDs I could find are usually around 1.x volts. So I know I have to use appropriate resistors before each LED. I was wondering if the difference between the battery and the LEDs is large, would this be advisable? Like if the 2 LEDs were 3v combined and the battery was 9v. Would the 6v difference that the resistors had to reduce voltage by drain the battery more than if I could find LEDs that combined were closer to the 9v battery? I don't know much about how this works. Thanks!

Follow-Up Postings:

RE: LED Light Circuit

Without getting into an explanation of how diodes work electrically, you need to limit the current flowing through the diode to not exceed what it is rated for lest it will burn out.

A typical (red lets say) LED has a 1.8v voltage drop and wants to be drive with 2ma of current (look up the specs on the diodes you wan to use). That means you need to size the resistor so that it flows no more than 2ma. Since the LED voltage drop is constant (for our purposes) the resistor must drop 7.2 (9v - 1.8v) volts.

Ohms law E=IR. 7.2 = .002 R
R = 3600 ohms

Now the only downside to using a battery bigger than 1.8v is that the resistor is going to dissapate some power (as heat). Twinkle, twinkle, little star, power equals i squared r.

P = .002*.002*3600 or 0.0144 watts. Not too much.

RE: LED Light Circuit

Ron's explanation is correct, however, a typical 5mm red LED current is actually 20ma - not 2ma. So, using the same math the current limiting resistor becomes 360 ohms. Standard 10% resistors in that range come in 330 and 390 ohm values - so you'd use a 390 ohm resistor in this case.

 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!

Return to the Electrical Wiring Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.

Learn more about in-text links on this page here