1st thing that comes to mind is: was the oil & color well mixed into the wax? I know it sounds like a stupid question, but some oils mix in slower than others. Sounds like you had some oil & color that hadn't incorperated into the wax totally, or may have been too much at one time. (I have a strawberry oil that makes great smelling candles, but is a PITB to mix in. Just makes little globules in the melted wax. If I added an ounce all at one time I would never get it incorperated into the wax. I have to add about 1/4 oz at a time & stir & stir & stir. I usually give up at about 3/4 + a bit of oil because trying to mix that last bit in takes forever. BUT not alot of oils are that bad) you might want to melt your wax, then add the scent, GRADUALLY, so you can see if it's mixed well, then add your color, until you get used to mixing the oil. Some oils will also alter the color of the dye you are using. That strawberry, mentioned above, is alomst an orange color on it's own, so when I add it to a nice red dyed wax I always end up having to add MORE red to get it back to a red color Also with any scent add gradually...it's easier to add more scent, harder to add more wax because the scent is too strong. Was the oil designed for candle use? Depending on the wax, you may need to add some vybar to it, it hardens the candles & helps bind the scent. You MAY be able to remelt those down & add some more wax to them, maybe about 1/4 lb and repour them. just put them in a ziptop bag & practice with some others before you try to remelt. If possible, cut them up & remelt over very low heat. Don't leave them unattended while remelting. It may weaken the scent a bit remelting, and adding the extra wax will weaken it a bit, but it should help with getting the oil/color incorperated. can't promise it will work, but it can't hurt. I've had to re do candles before, and the "re-do's" turn out fine. As with any new craft, it takes practice to get good at it. Hazel |