Insect Control: Soaps and Detergents by W.S. Cranshaw 1 Quick Facts... Soaps can be used to control a wide range of plant pests. Small, soft-bodied arthropods such as aphids, mealybugs, psyllids and spider mites are most susceptible to soaps. The ease of use, safety and selective action of soaps appeal to many people. Limitations of soaps include the need to wet the insect during application, absence of any residual effectiveness, and potential to damage some plants. Soaps or detergents used for control of insects are applied as dilute sprays, mixed with water to produce a concentration of about 2 percent. Soaps have been used to control insects for more than 200 years. Recently, there has been increased interest in and use of these products. This change is due to a better understanding of how to use soaps most effectively and a desire to try insecticides that are easier and safer to use than many currently available alternatives. How soaps and detergents kill insects is still poorly understood. In most cases, control results from disruption of the cell membranes of the insect. Soaps and detergents may also remove the protective waxes that cover the insect, causing death through excess loss of water. Soap-Detergent Sprays Soaps and detergents act strictly as contact insecticides, with no residual effect. To be effective, sprays must be applied directly to and thoroughly cover the insect. Several insecticidal soaps are distributed for control of insects and mites. Available under a variety of trade names, the active ingredient of all is potassium salt of fatty acids. Soaps are chemically similar to liquid hand soaps. However, there are many features of commercial insecticidal soap products that distinguish them from the dishwashing liquids or soaps that are sometimes substituted. Insecticidal soaps sold for control of insects: are selected to control insects; are selected to minimize potential plant injury; and are of consistent manufacture. Some household soaps and detergents also make effective insecticides. In particular, certain brands of hand soaps and liquid dishwashing detergents can be effective for this purpose. They are also substantially less expensive. However, there is increased risk of plant injury with these products. They are not designed for use on plants. Dry dish soaps and all clothes-washing detergents are too harsh to be used on plants. Also, many soaps and detergents are poor insecticides. Identifying safe and effective soap-detergent combinations for insect control requires experimentation. Regardless of what product is used, soap-detergent sprays are always applied diluted with water, typically at a concentration of around 2 to 3 percent (Table 1). Susceptible Insects Most research with insecticidal soaps and detergents has involved control of plant pests. In general, these sprays are effective against most small, soft-bodied arthropods, such as aphids, young scales, whiteflies, psyllids, mealybugs, and spider mites. Larger insects, such as caterpillars, sawflies and beetle larvae, generally are immune to soap sprays. However, a few large insects, including boxelder bugs and Japanese beetles, are susceptible. Insecticidal soaps are considered selective insecticides because of their minimal adverse effects on other organisms. Lady beetles, green lacewings, pollinating bees and most other beneficial insects are not very susceptible to soap sprays. Predatory mites, often important in control of spider mites, are an exception: a beneficial group of organisms easily killed by soaps. Application One of the most serious potential drawbacks to the use of soap-detergent sprays is their potential to cause plant injury -- their phytotoxicity. Certain plants are sensitive to these sprays and may be seriously injured. For example, most commercial insecticidal soaps list plants such as hawthorn, sweet pea, cherries and plum as being sensitive to soaps. Portulaca and certain tomato varieties also are sometimes damaged by insecticidal soaps. The risk of plant damage is greater with homemade preparations of household soaps or detergents. When in doubt, test soap-detergent sprays for phytotoxicity problems on a small area a day or two before an extensive area is treated. Plant injury can be reduced by using sprays that are diluted more than the 2 to 3 percent suggested on label instructions. To reduce leaf injury, wash plants within a couple of hours after the application. Limiting the number of soap applications can also be important, as leaf damage can accumulate with repeated exposure. However, because of the short residual action, repeat applications may be needed at relatively short intervals (four to seven days) to control certain pests, such as spider mites and scale crawlers. Also, application must be thorough and completely wet the pest. This usually means spraying undersides of leaves and other protected sites. Insects that cannot be completely wetted, such as aphids within curled leaves, will not be controlled. Environmental factors also can affect use of soaps. In particular, soaps (but not synthetic detergents) are affected by the presence of minerals found in hard water, which results in chemical changes producing insoluble soaps (soap scum). Control decreases if hard-water sources are used. Insecticidal soaps may also be more effective if drying is not overly rapid, such as early or late in the day. Soaps and detergents can offer a relatively safe and easy means to control many insect pests. As with all pesticides, however, there are limitations and hazards associated with their use. Understand these limitations, and carefully follow all label instructions. Table 1: Approximate mix to produce various dilute soap sprays. Percent dilution desired Approximate amount of soap to add to water to produce: Gallon Quart Pint 1 2 1/2 Tbsp (-) 2 tsp (+) 1 tsp (+) 2 5 Tbsp (-) 4 tsp (+) 2 tsp (+) 3 8 Tbsp (+) 2 Tbsp (+) 1 Tbsp (+) 4 10 Tbsp (-) 2 1/2 Tbsp (+) 4 tsp (+) (+) Will produce a solution of slightly higher concentration than indicated. (-) Will produce a solution of slightly lower concentration than indicated. 1Colorado State University Extension entomologist and professor, bioagricultural sciences and pest management. 12/96. Reviewed 3/08. Colorado State University, U.S. Department of Agriculture and Colorado counties cooperating. CSU Extension programs are available to all without discrimination. No endorsement of products mentioned is intended nor is criticism implied of products not mentioned. Go to top of this page. Updated Friday, August 03, 2012

I use an old squirt bottle filled with water. Then put a squirt of lemon joy dishwashing liquid in it and shake - The kind of dishwashing liquid for doing dishes by hand, not the dishwasher kind. Insects don't like lemon. The thing is you have to keep doing it weekly or so. It works for some stuff. Something was eating my strawberry plants and that took care of it. But now they are blooming so I stopped because I didn't want to discourage the bees. And I see 1 plant is getting eaten. So I don't know - do I spray again??? I guess I will because you can't have strawberries without a plant. I think it was white flies on my potatoes - I sprayed and I think it helped but I did it so late - who can tell the leaves are full of little holes. You have to get that stuff early and often.

Yes, it is called rebatching, and I will avoid it if at all possible. It's time consuming and tedious. To let you know, I make cp soap by the 10 pound recipes. I presently have 2 buckets of soap scraps, I would guess about a 2 or 3 cubic foot container. Instead of rebatching it I will add it to a new recipe of soap. Unlike what you have, this is still virgin soap scraps, not previously used. I will make soap and give these away or use them ourselves. What I would do if I had these previous used scraps, I would just add it to a new bar as they are being used; they do stick fairly readily, and they rarely come off. If you are going to still rebatch, I would grate them, then lightly mist them (not dripping) the night before, then add them to a crockpot on low or medium heat. You will need to set aside about 4 hours or so, depending on how much soap you need to do. The trick is to add just enough water (by the tablespoon) to keep the soap pliable and not dry, while you are trying to mash it, until it is thoroughly melted. Be careful, this soap is very hot while in the crock! Any scent of the scraps will disappear in the final product, so if you want it scented, then let the soap cool down a bit and mix in scent just before pour/mashing it into any molds. hth

Well, I'm not sure if I understand what you are asking. I make CP (cold process) soap and melt and pour soap. I have never had soap "stick" to the molds, if that is what you are referring to. What type of soap are you interested in making? If you are just wanting to learn, I would suggest you begin with melt and pour soap, using a top-quality base like SFIC. Making good soap takes a lot of practise and trial and error. Start simple, as with any hobby, and work your way up into better recipes, etc. Susan