I purchased a wacom tablet to use with Husqvarna 3D sketch software a little over a year ago. I also used it with my Husqvarna 3D digitizing software. I had the table a few months, loving it and then all of a sudden it quit working. The manufacturer told me that I had to deal with the local vendor to it replaced. After a bit of a battle trying to have it replaced by the local vendor who sold it to me they finally did give me a new tablet but after using it for only a short time it stopped working. The fault is not with my computer. I tried it on two computers and just purchased a new computer and it doesn't work on that new computer either. Has anyone else had the problem on the pen working in mouse mode but just will not work in draw mode?