|
| Hello,
Recently I had a new garage door installed. During the installation they had to chip a piece of concrete to fit the 2 x 4 wood framing. As a result I now have a 2 to 3 inch wide hole that is about 8 inches in height. The depth of the hole is about 3 inches. What is the best way to fill this hole? From inside the garage I can see light coming in so the hole goes straight through. Went to Home Depot and they suggested using quikcrete to patch the hole followed by sand quikcrete mix to finish the outer portion. Would post a picture but I don't see any link to upload. Any suggestions would be appreciated. Eric |
Follow-Up Postings:
|
- Posted by sierraeast (My Page) on Sun, Jul 10, 11 at 11:31
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Home Repair Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.