Return to the Home Repair Forum | Post a Follow-Up

Rotting wood beams at the base of my garage

Posted by kimcoco (My Page) on
Tue, Jun 12, 07 at 15:27

Our garage is built up against a slight hill, so the backside of the garage has about 2-3 feet of soil sitting up against the wood siding. Obviously, the builder wasn't educated on the topic of rotting wood at that point in his career. Our neighbor's garage is directly behind ours by about 3-4 feet, but theirs sits higher as their garage is above the soil level on top of the hill.

As a result of the builders ignorance, water drainage from the soil leaks into the back of our garage where the floor meets the wall, and the 2x4's show some serious rot. So, we need to know how to replace and/or fix the rotting wood without tearing out an entire 2x4 or affecting the structural beams. This is so we don't have structural problems later on with the rotting wood, or worse yet, carpenter ants.

I need to know if this is the proper way to do this:

We were thinking of digging up the dirt behind the garage, temporarily, so that we could get a liner in between the soil and the garage.

Once we remove the dirt, we are able to access the other side of the rotting wood at the base of our garage and hopefully replace some of it. Some of the wood is vertical, and some studs are the horizontal beams. My first question is, can we just "cut" the rotting pieces out and screw replacement wood in without affecting the structural support? As far as the vertical beams, we could add a separate wood piece and attach it flush to the vertical beam and screw them in for support while we cut or saw out the bottom part of the existing 2x4, and then replace the removed pieces with good wood. Then we'd screw them all together for support. Does this make sense?

Once the wood is repaired/replaced, we were thinking of adding a thick plastic liner against our garage so that the wood doesn't touch the soil when we add it back in. We were also going to fill the top foot or so with pea gravel so that water runs off better.

So, I really have two issues here. How to replace or fix the rotting wood, and what to do with the soil that sits up against my wood sided garage to prevent further decay. We are eventually getting the garage sided with vinyl siding, but not this year.

Is this the correct way to do this? Or, can I just use bondo or wood filler on really rotted wood????

Thanks in advance for feedback.

Follow-Up Postings:

RE: Rotting wood beams at the base of my garage


You have to fix the first problem - soil and drainage. Have you investigated putting in a retaining wall on the back side of the garage? Placing plastic sheeting and then filling the dirt back in won't cure the problem.

My suggestion is to build a retaining wall about two feet out from the garage. The height will be determined by the slope you have. After that, install curtain drains covered with pea gravel. The water will filter down through the gravel and the curtain drains will take the water around the garage.

After fixing the soil and drainage, replace the rotting wood with pressure treated lumber. You will probably have to sister wall studs that are rotted out with the wood that's still good. I'm not an engineer and with no visual to go on, I would assume you are going to need to support the rear wall while replacing the rotted wood.

Under no circumstances use bondo or wood filler on rotted wood. Cut all the rotted wood out.

If all else fails, consult a contractor.

RE: Rotting wood beams at the base of my garage

The problem with a retaining wall is that I own only 1 foot of property behind my garage, and there's only 3 feet between my garage and the neighbors, so a retaining wall isn't feasible. To make it worse, we don't have nice neighbors. They're jerks, to put it nicely.

So, any other ideas?

RE: Rotting wood beams at the base of my garage

Based on how you've described the location, I don't think you're going to have a way to stop the water flow. This probably isn't what you want to hear, but I'd start saving $$ so that I could plan a new garage in a different location in your yard.

We had the same rotting 2x4s, rotting from the bottom up, in our old garage which resulted from the base of our garage being lower than all surrounding area (partly due to settling that occurred long ago). We woke up one morning this past March and there was 4" of standing water in the garage - melting snow, slushy rain and horrible drainage. We are now the proud owners of a new garage which was raised 1 foot and we're now higher than what's around us.

With that other garage by yours, I think your hands are tied.

RE: Rotting wood beams at the base of my garage

My dad fixed a similar garage problem once, here's roughly what he did.

1) Dig out the dirt from behind the garage.
2) Use heavy lumber and masonary blocks to establish temporary support for the upper part of the wall so you can.....
3) Demolish the entire lower portion of the wall.
4) Set up forms to pour a concrete wall in place of the rotten wooden lower wall. You could instead build it up using concrete masonary units ["cinderblock"].
5] Lower the upper wall onto the new masonary lower wall and remove temporary supports.
6) Replace soil at the back, addressing the drainage problem [perhaps curtain drains as described above] in the process.

RE: Rotting wood beams at the base of my garage

Kec01, we're on less than 1/4 acre lot, so moving the garage isn't feasible. We have no where to go with it.

Airgual guy, that was also something that I thought of - adding cinder block / concrete wall along the bottom portion. Sounds like a lot of work, but I also think it's the most practical, though I don't know if it's something we could (or would want to) do ourselves. I'm assuming Rhibar (Sp?) is added with the cinder blocks for support.

I wouldn't even know who to call about this. What contractor would specialize in fixing something like this?

RE: Rotting wood beams at the base of my garage

A GC will handle it just fine.
It is not as hard as it really sounds.
A temporary wall is built inside the garage a few feet from teh wall to be rebuilt.
Depending on the existing framing it can be pretty simple, or require some creative shoring.
If it is a gable wall in a one story garage it may not even be worth saving.

RE: Rotting wood beams at the base of my garage

Here's an article on replacing a rotted sill plate in a garage, which shows how they supported and lifted the structure during the work. It's not your particular issue but similar enough to give you some insight.

RE: Rotting wood beams at the base of my garage

Rebuilding the wall so that the bottom section is masonry seems like the obvious and correct fix; nothing else is going to be a long-term solution. No membrane is going to save an untreated wood wall below grade for long. 2-3 feet of soil against a wood wall is crazy.

RE: Rotting wood beams at the base of my garage

Thanks everyone for the feedback - very helpful.

Talk about a money pit! The ONLY thing we haven't replaced or fixed on this house yet (besides the garage wall) is the water heater, and that's gradually dying. Within the past two weeks, we've noticed the hot water heater is leaking, our 3 yr old piece of crap GE profile side x side refrigerator is leaking and temperature controls range from zero to 22 degrees on the freezer, and 37 to 44 degrees on the fridge, AND my basement sewer drain has backed up the last two times I've used the dishwasher.

Does it ever end???????

RE: Rotting wood beams at the base of my garage

It never ends...sometimes though you'll get a little time between repair problems. Seems like everything's happening to you all at once though. What did you decide to do about the garage? Do you think you'll try snaking the basement drain yourself? It's a heavy job but it can be done by a homeowner for a lot less than having a plumber do it.

RE: Rotting wood beams at the base of my garage

I have the same problem that is shown in the link that bill g web refered to. I have fixed the water issue by digging down below the foundation, and putting in a drain, covered by stone. The instructions on that link have you jacking the garage up a few inches, replacing the sills, and then lowering it. The problem is that the exterior is brick, and it seems that jacking up the garage will only cause problems with the brick. Any suggestions?

 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!

Return to the Home Repair Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.

Learn more about in-text links on this page here