Return to the Home Repair Forum
| Post a Follow-Up
mounting a board on floated drywall
| | |
Posted by civ_IV_fan (My Page) on Fri, Jan 20, 12 at 13:12
| this seems pretty basic, but i'm not quite sure about the best approach.
i'm hanging a 1x4 board horizontally in my kitchen and a 1x2 parallel beneath it. the 1x4 will have hooks in it to hold my cast iron skillets and the 1x2 is a bumper to protect the wall.
my kitchen is drywall that is floated out from the plaster underneath with furring strips. so the studs are nearly impossible to find and in any case very deep being beneath drywall, an air gap, plaster, and lath.
my first thought was to mount my board to the furring strips, but that doesn't seem like a good idea because of the weight. my next thought is to use wall anchors, but then i would have large screw heads exposed on the front of the board.
any ideas for this basic task? ideally, i'd like to not see any evidence of the fastener on the front of the board. |
Follow-Up Postings:
RE: mounting a board on floated drywall
| | |
| How thick are the furring strips? You may need to find the studs and use long enough screws to reach well into them, and make sure they are large enough (diameter) screws for the weight also. Another alternative is to open up the drywall, then the old wall, and install blocking between studs. I have a bunch of copper pans on a rack, and it is mounted with 1/4 lag screws well into the studs. It is a half circle so it sticks out about 16 inches and provides a lot of leverage, despite having an angled brace on the top. You will not have as much leverage hanging the pans almost flat to the wall, but the load is still very high when it gets to a few screws into studs. |
RE: mounting a board on floated drywall
| | |
| well i can insert a nail about 1 1/4 inches into the sheetrock before i feel them hit the plaster. if the sheetrock is 1/2" (installed years ago, may be thicker), that means the furring strips are about 3/4" it's a fairly narrow area and i'm only hanging two skillets up. the weight load will be about 30 pounds. the length of the board is about three feet. |
RE: mounting a board on floated drywall
| | |
| use a 2 1/2" trim screw. The head is no bigger than a nail head and can be puttied |
RE: mounting a board on floated drywall
| | |
| There are also "buttons" designed to insert into exposed screw heads. |
RE: mounting a board on floated drywall
| | |
| thanks for the help, everybody. i ended up using 1 1/2" wire brads to affix the board to the wall, mounting it to the furring strip underneath. then i took two 3" #6 screws with small heads (the longest trim screw i could find was 2 1/4") and ran those into the studs, one on each end of the boards. i think i grabbed about 1/2" of the stud underneath. it is holding great. now if only i could figure out a way to get my wife, who asked me to do this, a way to say thank you or something other than, "i can't believe you painted the end of the board white" -- that's all another story though |
Post a Follow-Up
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Home Repair Forum
|
|
|
