Shop Products
Houzz Logo Print
ls973800

Pump Continually Starts/Stops

ls973800
11 years ago

The pump for the pool has been running/stopping/running several times that I've noticed lately.

It will stop for about a few seconds and start right up, run for a minute or two, stop again for a few seconds, and start right up again. The Hayward pumps are about 5 years old as is the pool.

Last year I was having a problem with the check system light saying no cell power. I had found the forum and repaired the K-1 solder connection. Yesterday I checked the board and the solder is still good on the repair.

This morning the pump was doing the on/off/on for about ten minutes and then continued to run OK until the timer shut it off.

I don't know if a pump is overheating (one pump for the filter, one for the sweeper/vac), or if a sensor is bad. If the pump were overheating, I would think it would stay off more than a few seconds or so. When it stops, the diagnostic on the control panel says Chlorinator Off/ Filter Delay and starts a 60 second countdown. The pump is running during this time.

This post was edited by ls973800 on Fri, Feb 1, 13 at 16:46

Comments (9)