|
| Hey there,
My Minimax NT just displayed HI on the led display. After reading through the manual it appears that one of my HI-Limit thermostats are acting up. My pool water on temps out at 70 degrees! I was wondering if one can bypass the Hi-limit thermostats as a way to figure out which one is bad. I actually tried doing this one at a time and I still had HI on the display after powering back up. I did remove each Hi-Limit thermostat to check for mineral build-up. Neither one was exceptionally dirty. I did brush them both off and reinstalled them. Still no luck. Is there any other source for the HI code on the display or am I on the right track and replacing both Hi-Limit thermostats should solve the problem? Thanks! |
Follow-Up Postings:
Post a Follow-UpPlease Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Pools & Spas Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.