|
Fri, Oct 22, 10 at 9:25
| We had a waste king disposal installed yesterday. The water is now VERY slow to drain (ie when clean water is just running from the faucet into a clean sink it pools). Could it be the rubber flange thing that covers the drain is too tight and not letting water down fast enough? when we push it around the water flows more freely - can we trim it or adjust if?) Or could a bad installation do this? Thanks. |
Follow-Up Postings:
|
| "Could it be the rubber flange thing that covers the drain is too tight and not letting water down fast enough?" They tend to become more floppy with age. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Plumbing Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.