Return to the Plumbing Forum | Post a Follow-Up

 o
Sewer Cleanout Cap

Posted by saak (My Page) on
Sat, Jun 26, 10 at 16:26

Hi All, My name is Jason and I am new to this forum. I have a question about the sewer cleanout in my new house (San Diego, CA)... it is located in the sunroom. I want to eventually remodel this sunroom and would like to deal with this opening somehow, but for now I need to eliminate some of the funkly smells in this room (mostly cat urnie type smells). The current cap is not attached. It just sits on the top, can I buy a new cap that would fit this? Here is a pic:

Here is a link that might be useful: Sewer Cleanout


Follow-Up Postings:

 o
RE: Sewer Cleanout Cap

If the pipe is threaded, you can use a threaded plug. If not, you can get the plug type that has a rubber piece that expands out to seal as the nut on top is tightened (that is what your current plug appears to have been but is now missing the actual plug part). Either way, do it immediately since you currently have sewer gases entering your home - not good. Home Depot, Lowes, or any plumbing supply store should care what you need.


 o
RE: Sewer Cleanout Cap

Alice suggests a good temporary quick fix by inserting the proper sized test plug to stop the gasses from stinking up your room. From what I could determine, the pipe is plastic. You could glue in a sleeve with a threaded cap in it.


 o
RE: Sewer Cleanout Cap

Thank you very much for your help. I ended up buying "Chernes Gripper plug" and it seems to fit tightly.

I also bought a threaded sleeve/insert that fit snug, but could be pulled out fairly easily so I took it back. Is it possible too use PVC primer/cement to install the sleeve (then use the threaded insert with teflon tape)?


 o
RE: Sewer Cleanout Cap

Careful here. That cleanout is in an open area in the floor. If you install an expanding test plug as was suggested above the threaded rod and nut on the plug would extend slightly above the floor surface and present a trip hazard. The same would be true if you installed a threaded sleeve and a conventional cleanout plug. In this case the Nut on the cleanout cap would also extend upwards above the floor, creating a trip hazard.

The proper solution would be to cut the pipe flush with the floor, install a threaded sleeve flush with the floor, then install a cleanout cap with a recessed square wrench opening to insure there is nothing protruding above the floor line.


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Plumbing Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here