|
Mon, Jun 13, 11 at 4:59
| I connected the braided hoses to the hot and cold water supply and the lines where too short, but I forced the connection anyway and pinched the end at the crimp and water is dripping now. I have a waterfall type faucet and the hoses go into the unit that I cannot access. I tried to take it apart to remove the old hoses, but I just cannot get to the other end to unscrew them. Is there anything I can do to repair the leak like cut and crimp on a new connector or any other ideas? Everyone's help is greatly appreciated. |
Follow-Up Postings:
|
| New hoses. The braided hoses are not repairable. |
|
| brickeyee is correct. Gonna have to get into it to replace en-toto. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Plumbing Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.