Today I installed a new Fleck 7000 SXT water softener with 1.5 cu ft of resin (see this post for the recommendations). I'm not sure if I got the programming right.
Basically the only change I made was to the hardness (9). Afterwards I initiated a manual regeneration and sat back to watch. The brine draw is set to 60, but when I checked at 40 minutes the water in the brine tank was gone. The level appears to be at or below the bottom of the air check valve. The brine fill cycle is set to 12 minutes, and that didn't appear to add a measurable amount of water to the brine tank.
What did I miss? I've listed all the settings from the Master Programming mode below. The BLFC from the sticker on the valve is 0.125 gpm.
DF: GAL
VT: dF2b
CT: Fd
C: 35
H: 9
RS: rc
RC: 0
DO: 14
RT: 2:00
B1: 10
BD: 60
B2: 5
RR: 10
BF: 12
FM: t1.2
User
esoesoyOriginal Author
Related Professionals
Miller Place Plumbers · Cloverly Kitchen & Bathroom Remodelers · Blasdell Kitchen & Bathroom Remodelers · Crestline Kitchen & Bathroom Remodelers · Dearborn Kitchen & Bathroom Remodelers · Hanover Township Kitchen & Bathroom Remodelers · Key Biscayne Kitchen & Bathroom Remodelers · Oceanside Kitchen & Bathroom Remodelers · Overland Park Kitchen & Bathroom Remodelers · Pico Rivera Kitchen & Bathroom Remodelers · Vancouver Kitchen & Bathroom Remodelers · Walnut Creek Kitchen & Bathroom Remodelers · Wilson Kitchen & Bathroom Remodelers · North Chicago Kitchen & Bathroom Remodelers · Wellesley Kitchen & Bath FixturesUser