Some things to think about: - There really are no cr@ppy DSLRs being sold anymore. Even the new low-end cameras offer the latest in image-processing software and lens technologies. - Even the low-end cameras also offer more than enough resolution (megapixels) for anything short of poster-sized prints. Don't get caught up in the megapixel race. It's like deciding between a car with 300 hp and one with 400 hp. Either will get the job done; your camera choice should be based on more than just raw power. - You really should handle the camera you plan to buy. Some people find some cameras too large to handle comfortably. - The camera you buy should allow you to output pictures in RAW format. This format contains more picture information so you can manipulate it digitally later without losing picture quality. - It's a fact that most people buying SLRs these days never use more than the lenses that come in the box with the camera. Unfortunately, these "kit lenses" typically are not the best the camera manufacturer offers. Check out what other lenses the manufacturer offers and consider lenses sold by third-party manufacturers as well. You may find your pictures are noticeably better with a lens other than a kit lens -- especially one designed for the kinds of images you want to take (macro, telephoto, etc.) - Some manufacturers offer image stabilization. This can be useful in getting pictures in low-light or fast-moving situations. The two types of IS are in-lens and in-camera. In-lens is better, but it means you're paying for IS with every lens you buy. Hard to say if one choice is better than the other. :-P - Keep in mind that DSLR technology is still evolving some. Back when film SLRs were popular, it made sense to spend a good chunk of money on a camera you'd be growing into for 10-15 years. Given how quickly improvements still are being made, it doesn't make a lot of sense to spend well into four figures for a DSLR while you learn to take better pictures. Most DSLRs just aren't going to have that long a practical life. Good luck!

Has anyone inspected the chimney ? Muffler tape will work but the thing is it was never intended to wrap furnace pipes because furnace pipes do not normally spill out grit. Are your flue pipes galvanized ? If kept up a 20 year old furnace is not old. They actually made a good furnace in those days. i wouldn't blame the furnace just yet. there might be something else causing this. I've seen one insident that is very rare might not be your problem but i was with my journeyman on a call. White grit was on the flue pipes. took us 8 months to figure it out. The basement was very damp. Very hard ground water in the area. As the moist air condensed on the flue pipes it left behind the calcium from the water. The flue pipe turned white. you don't say where the furnuce is located. If the grit collects underneath i'd think, Moisture ? It's a stab in the dark. See what your oil guy says. Oh yah. You might not want to do this but taste it. Is it chalky ? If it is chalky it's calcium. Actually if you can write your name in it it is calcium. As i said before see what your oil guy says. After all he is the one you are paying.

Hi. I'm so glad to find this thread and hear your good experiences with the Canon Powershot SD1100. That is one of the ones I'm thinking about. The other considerations are the canon powershot sd880, and the sony cybershot dsc-w300. There might be a panasonic linux or Olumpus I'd consider as well. Here are the things I'm hoping to find: - very small and portable - 7 ounces or less, can fit in a pocket (even if snuggly) - very very good picture quality. I sometimes sell on ebay and craigslist and a good photo can make a huge difference in whether you make the sale - and what price you can get. most of those items are still, relatively small items (2 feet diameter to a couple of square inches) - being photographed indoors. - pictures of my daughter and family and friends - more indoors than outdoors. I don't like what my 5 yo olympus does to skin tone and other items used indoors with flash - I want either a flash that doesn't wash out and overexpose - or a camera that doesn't blur if i try to hold it still for an indoor shot without flash. This is very important to me. - I'd prefer a viewfinder - but might be willing to give this up for other features. - a zoom of at least 3x (if there's a reason I should have more, please let meknow) - maybe the ability to change settings or do a little manual adjustments - I don't know how to do this now, but I'm hoping to have this camera for a few years and I might be interested in learning a little more soon - here's what I think I can't have everything - occasionally get an action shot of my daughter - dancing, playing, etc - ability to take reasonable quality video - I'd probably use wide angle if I had it, but I haven't had that feature on a camera in over a decade. Price - under $400. under $300 is better, but I'd pay a bit more if there were such a thing as having it all. From what I've read of the samsung l210 and casio exilin card ex-s10, they seem to only have good image quality.. And now for a separate question. My camera is a 5 mp, olympus camedia c-50 zoom. I believe it's 5 years old (maybe 6). Will I gain a noticeable improvement in quality and features that would make it worth my while to upgrade from this camera. It used to seem to me I could get decent pictures on this, but now when I take pictures of my daughter or items to sell, I dislike more than half of them - they're either too blurry, or not lit well. I do have more handshake than I used to - so image stabilization might be very worth my while. Thanks. Lynn. PS - I started really seeing what crisp clear pictures could be like from the kitchen and cooking forums here.

there is a plant propogation book i have wherein the author describes his own mist system. that author has a large black coil of hose in the roof of his greenhouse so that water can be heated before reaching the mist nozzles. that's at least one vote for using warm water and keeping the cuttings reasonably warm as they root. just thought i would toss that in! lol. -------------------------------------------------------------------------------- Posted by: mosaic z8 LA (My Page) on Sun, May 11, 03 at 11:59 With such a setup you could probably root roses under mist all winter here in Louisiana. And then as an added bonus, you could save on your power bills all summer by using it to steam your veggies :) -------------------------------------------------------------------------------- Posted by: tammyinwv z6/WV (My Page) on Sun, May 11, 03 at 16:05 i have been unable to find the mist heads even within an hr from my home.Someone mentioned here they found them for .50 each.would anyone be willing to get me a couple and mail them? -------------------------------------------------------------------------------- Posted by: wild_garden virginia z6b (My Page) on Sun, May 11, 03 at 16:32 at my lowes store the mist heads where in the indoor gardening area next to the register, i doubt the people at lowes would have even know what to look for. it was with the drip irrigation supplies, as i said in the indoor gardening area next to the big outdoor area where they sell trees and things. -------------------------------------------------------------------------------- Mist heads supply source Posted by: RoseHawke 7b AL (My Page) on Mon, May 12, 03 at 10:37 For you folks that haven't been able to find the heads locally, try going to this site: Dripworks or here's a direct link to one of the pages with some heads:Misters . I just a couple of weeks ago ordered some irrigation supplies from them and received them quite quickly. About 4 days if I remember correctly. Haven't had a chance to put it together yet, which is probably just as well as the flood we had last week would've probably washed everything down the creek ;-). I also have the Melnor timer, and it does seem a bit confusing about its ability to do a mist cycle, but what you're doing is programing it to do one cycle (on in the am; off in the pm) and punching in a choice of watering pattern, in this case the off for 10" on for 2" pattern. I believe the idea behind the pattern was/is actually to help prevent water run-off when doing overhead watering by allowing the water to soak in between the on phases. I bought this particular timer though because when I looked at it my mind said "Ah! Mist!" (heh), even though the reason I bought it at the time was to keep a new patch of zoysia sod watered until it rooted in. My batteries did last all season last year, but it was only opening that valve 4x a day for 3 weeks, and then 1x every 4 days for a couple of months. I can see where a misting pattern of opening and closing that valve many times during the day may eat batteries, but as ShamanSherpa pointed out, it's still cheaper than a $100+ misting timer! -------------------------------------------------------------------------------- Posted by: patclem z7 (or 6) TN (My Page) on Fri, May 23, 03 at 8:32 Regardless of how much water it wastes, etc, I decided to experiment with misting. I am TERRIBLE at rooting cuttings. I've tried baggies. I've tried jars. I've tried special cutting trays with plastic domes. I've had one rooted cutting out of probably 50. I had the same problem finding true super-fine mist systems in the south. None at Lowe's, none at HD. They're not popular here because they don't have the same evaporating effect they have in less humid areas of the country - they make you wet here. Here's where I found mist heads. They didn't charge me anything for shipping. They were super-good to deal with online. Web Page - Phone/Fax 888-693-0578 Local/Fax (719) 495-2266 Qty: 4; Sku: 6W401; Product: Monarch Misting Nozzles M-1; Amount: $7.40 Qty: 4; Sku: 6W519; Product: Reducing Tee for Monarch Misting Nozzles; Amount: $4.40 You have to go to Lowe's or local hardware store and get a hose adapter, timers, 1/2" PVC, PVC caps, etc. I have mine set up with 2 mist heads, and about a 6' diameter section of my grass is soaked! I don't have mine on a timer yet. Results? I don't have any yet, except none of my cuttings have turned black yet. PS - I AM NOT AFFILIATED WITH THIS BUSINESS IN ANY WAY! Here is a link that might be useful: Mist Heads -------------------------------------------------------------------------------- Posted by: fuselighter 7/WA (My Page) on Thu, May 29, 03 at 21:41 I am so excited about the misting bed. I went out and bought all the supplies today. Total cost was about $15 (my husband had PVC and elbows left over from installing the sprinkler system). I would like to go to an intermittent system eventually, but for now I am going with continuous. The water bill is not an issue because we have an irrigation system (there is an annual fee but it is not based on usage). I set the whole thing up in about an hour. -------------------------------------------------------------------------------- Posted by: debbinard Z4CO (My Page) on Sun, Jun 1, 03 at 10:54 Shamansherpa -- I could not open your picture! I live in Colorado, it gets very warm middle of June (up to upper 90's) and stays low humidity. We are on outsidewater restrictions 2xweek, so I'm not sure this method would fly. Am wondering how visible this is, or if inside is an option under lights. At any rate, I would like to propigate some rose cuttings now (is this a good time?) My daughter in law is moving and would love some plants from a rose with sentimental value. Is the rooting hormone used just the usual or special for roses? Thanks Deb -------------------------------------------------------------------------------- Posted by: mytrid Zone8b Florida (My Page) on Sun, Jun 1, 03 at 13:48 Deb, Maybe you could call your water extention office and see if you can get special permission, exsplain to them how little water it uses. Yes you use rooting hormone, there are many available. Dip and grow I here is supposed to be really good. I got some of the more exspensive stuff from a friend whom bought it threw rose imporium on line. But you can always use something like dip and grow. Deanna -------------------------------------------------------------------------------- Posted by: rose_enthusiast z7 TX. (My Page) on Sun, Jun 1, 03 at 15:47 Hi there Deanna! It seems to me you've managed to help a lot of people with your invaluable info. And I would like to thank you for inspiring me to start a misting bed to root my cuttings. I have one question to add to the many others you've been getting though... What rose company is it that you get your rooting hormone from? Is it Rose Emporium or the Antique Rose Emporium? I would like to purchase this product as well, since you and this company are using this to successfully root your cuttings. Thanks Again, Carlos -------------------------------------------------------------------------------- Posted by: mytrid Zone8b Florida (My Page) on Tue, Jun 3, 03 at 1:31 Carlos, Thank you but we should all thank AngieAnders, she is the one who did all the research and work to discover this method and then post it here for us last year! She truly diserves all the credit. I just wanted to keep any new people aware that have just started rooting this year. Best of luck all and don't forget to post your sucess! Deanna -------------------------------------------------------------------------------- Posted by: epiphany z5b PA (My Page) on Tue, Jun 3, 03 at 9:28 I found the Arizona Mist system which is by Orbit as mentioned at Wal-Mart. It has 12' of tubing, end cap, six misting heads and hose adapter for $14.95. Of course, it is once again cold and wet here,......all of a balmy 56°. -------------------------------------------------------------------------------- Posted by: auntnana 6 TN (My Page) on Thu, Jun 5, 03 at 13:06 I ordered the misting heads mentioned above from Dripworks last year and they don't put out a fine mist as much as they do a fine spray/droplets. And even though I had a pressure regulator on there, I kept having a problem with the heads blowing off! (Their drippers work perfectly by the way so it's nothing against the company) I ordered foggers from Misty Mate this year and they put out a super fine fog. Perfect for propagation. They are a litte more expensive than the ones from Dripworks but worth it. And if you ask they will ship the misting heads for $1.50. I went to HD and bought a 10-24 tap and drill set (3.00) and drilled holes in my 1/2" cvpvc and the heads just screwed right in! I bought a Melnor timer at HD for $39 and it has 1 minute spray options so I've got it set for 1 minute every 10 minutes. Can't remember the model number but it's not the one on the HD website. I hope to finish my new propagation box soon. I built one on a stand this year so I can move it around easily. Wouldn't you know, HD has plastic sheeting made just for greenhouses that I used! It's not the real thick heavy stuff either. It's only 4mil and is crystal clear see-thru! Hopefully I'll be finished this week!