Return to the Organizing the Home Forum | Post a Follow-Up

 o
Dumbbell rack - ideas

Posted by laura7051 (My Page) on
Tue, Mar 25, 14 at 15:16

All the racks I see for dumbbells seem like overkill for my humble collection of vinyl-coated dumbbells, and expensive to boot. But i do want to get my dumbells off the floor in some semblance of order.

I currently have 7 pair, ranging from 1 - 8 pounds per dumbbell. While brainstorming, I determined that I could hang one dumbbell vertically from a tool hook we have that looks like this - double-pronged straight hook - see attached photo.

The hooks hold up to 15 pounds. I thought I could mount a two 2x4s to our basement wall to accomodate a couple rows of these hooks and I'd be set. I believe the dumbbells would be easy enough to remove and replace from the hooks as needed.

My main question is how to securely mount the 2x4s to our basement/ foundation walls. Unlike our garage walls, I believe the foundation is solid concrete. My plan is to hang a board long enough - horizontally - to accomodate about 10-12 of these hooks. What type of screw/fastener would be used to mount the 2x4?

Does anyone have any other/better ideas related to my idea?

Thanks!


Follow-Up Postings:

 o
RE: Dumbbell rack - ideas

Look for information on concrete wall anchors. Attach your 2x4s to the wall with a few anchors (just like you would mount them to studs first), then screw in your dumbbell holders.

I would try one in the garage on a bare stud first, though, to make sure it will work. It seems to me like you'll have to put the hooks very close to the top of the board, and have the board stick out far enough to accommodate the "bell" part above and below. Getting that distance right - enough room to hang the barbell, and enough board to support the screw - might be the tricky part.


 o
RE: Dumbbell rack - ideas

I have four dumbbells, and made a basement rack out of 3/4" plywood for them. Two of my three barbells are downstairs. But it turned out that I really needed two dumbbells upstairs. I have not made a rack for them yet.

I already had many wood DIY shelf units, so a space was found between two existing shelf units that was just large enough for the barbells. This way I did not have to worry about attaching to a wall. I just screwed two pieces of plywood to the existing shelves. They already had four cut outs for my four dumbbells to be slip into. Six screws did the trick, it rests on the floor.

My dumbbells are the Wal-Mart screw on type that take plates.
Since I keep wood scraps it didn't cost anything to make the rack.


 o
RE: Dumbbell rack - ideas

that should read --

,... was just large enough for the dumbbells.


 o
RE: Dumbbell rack - ideas

Thanks for your responses.

Of course after having given up on finding an inexpensive store-bought rack and presenting my idea here for a DIY one, I recently found a reasonably priced ready-made rack that'll likely work.

I will save our efforts for finally installing our gladiator garage storage system. We bought the parts last November and it suddenly turned too cold to work in the garage. Our main challenge is securely fastening the gear track to our hollow cinder block garage walls. I believe my boyfriend found an anchor type product that will work, but I'd feel better if we also used some construction adhesive to boot.


 o
RE: Dumbbell rack - ideas

hooray for finding something ready-made and reasonably priced!

Good luck with the storage-system installation!


 o
RE: Dumbbell rack - ideas

Oh, I was going to say--if you still needed to make your own rack--you could screw those hooks into a piece of 3/4"-thick plywood and then just lean the plywood against the wall. Put rubber feet on it, or something.

Or use a couple of door hinges to attach two pieces of plywood or board into an A shape, and put the hooks on either side. Then it would stand alone (you could attach a chain inside or use cross braces to keep the A shape from moving around.


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Organizing the Home Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here