Shop Products
Houzz Logo Print
chipster_2007

How to make a large door hole smaller

chipster_2007
10 years ago

I could really use your suggestions re this problem.
I attempted to install a dead lock bolt into a door using the DeWalt lock jig and have run into a little trouble. When installing the lock, I realized it wasn't a level cut and took a little more off than I should. When the lock is installed, there is a circular exposed area (1/16 " - 1/8") around one side of it which the faceplate of the lock, front and back, does not cover. What would be the best (and easiest way) of repairing this? I have thought of cutting a circular piece to fit in there but how. What would be the best glue to use in correcting this problem? Thanks

Comments (3)