|
| Hello,
I have problems with Okuma LC-10 OSP 3000 (1981) programming unit 7-segment display. As you see on the picture link below on the left upper corner of the picture, 7-segments are not working : http://www.dynomec.com/okuma2.jpg Here is another view inside unit : http://www.dynomec.com/okuma1.jpg Schematics for 7-segment are here : http://www.dynomec.com/okuma3.jpg A LOT of other files and pictures you may find from here : http://www.vauhtikauppa.com/Okuma.zip Shortly the problem could be the display data latching failure. So, if anyone have faced same problem, please tell what could be wrong or which part to replace? Does anyone know where to get spareparts? Does anyone have IF12 board electrical schematics or any ideas where to get? IF12 board is located on main cabin and is a possible reason. Its serial number is : E4809-032-399-C All advices very welcome, I would like to get Okuma back running again. BR, Harri
|
Follow-Up Postings:
Post a Follow-UpPlease Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Metalworking Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.