|
Sat, Jul 14, 07 at 13:49
| Hi. I am not sure if this is the right forum but here is my quandary. I have my range hood (cast stone) being installed today. When I ordered the hood, the manufacturer told me the ventahood 40 3/8" insert would fit. I gave them a bunch of different sizes and the 40" was what they recommended. Apparently, they were wrong. I actually have only 38". The liner is not returnable and cost $900 so I really need to figure this out.
Here is my question. Can I have the liner cut down an inch on each side and who exactly would do this? I know I could do it but I certainly would not like looking at it when I was done. Sheetmetal and I do not mix well. Thanks for any recommendations. |
Here is a link that might be useful: Ventahood BHPSLD 40 3/8
Follow-Up Postings:
|
| Never mind-I called a sheetmetal fabricator today and they said no problem! |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Metalworking Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.