|
Wed, Jan 26, 05 at 15:30
| I was recently searching through the web for articles on homemade metal benders, I found a post that was started sometime in september on this forum about a homemade bender that a few of the members had built, the posting was entitled My home made metal bender, and it was posted by kbeitz. The bender looks very good, but I have a few questions. My first question would be, is the bender able to bend structural tubing without kinking or creasing the metal? My second question is, is their any specific measurements that you can give me so that I can build the bender? Any help would be greatly appreciated.
Thanks
|
Follow-Up Postings:
|
| It will bend structural tubing with adapters with out kinks... |
|
| It will bend structural tubing with adapters with out kinks... |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Metalworking Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.