Return to the Metalworking Forum
| Post a Follow-Up
Question about homemade metal bender?
| | |
Posted by Algreen (My Page) on Wed, Jan 26, 05 at 15:30
| I was recently searching through the web for articles on homemade metal benders, I found a post that was started sometime in september on this forum about a homemade bender that a few of the members had built, the posting was entitled My home made metal bender, and it was posted by kbeitz. The bender looks very good, but I have a few questions. My first question would be, is the bender able to bend structural tubing without kinking or creasing the metal? My second question is, is their any specific measurements that you can give me so that I can build the bender? Any help would be greatly appreciated.
Thanks
Algreen
|
Follow-Up Postings:
RE: Question about homemade metal bender?
| | |
It will bend structural tubing with adapters with out kinks...
 |
picture
| | |
It will bend structural tubing with adapters with out kinks...
 |
|
|
|
|
