|
Tue, Oct 23, 12 at 19:05
| I have Asko W6222 washer (purchased in Australia) sold here as cold water supply only.
I wish to fit a hot-water valve and control circuit to it. In principal, quite easy for me as I am very experienced electronics technician, with the necessary skills. I do 'component-level' electronics work. However it is easier, if I have the electronics PCB schematic. Could do without it but that is a drudge! Asko parts manual only shows PCB, as a bare block with wires attached! Does anyone here know where that schematic drawing is available? Thanks for any clues or hints. Regards all, Clive Judd. |
Follow-Up Postings:
Post a Follow-UpPlease Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Laundry Room Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.