|
Thu, Jan 5, 12 at 23:50
| Our dryer was getting extremely hot while drying, but did not shut down due to the overhead cutout. The control panel is lit up, but stays only on P2 with three options. Nothing operates on the control panel. I checked the voltage across the thermister terminals on the circuit board and its about 4.98 vdc. The spec call out 5 vdc, which is pretty close. Anyone have an idea where I should start? Does a bad thermister cause the control panel to be come inoperable?
John |
Follow-Up Postings:
Post a Follow-UpPlease Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Laundry Room Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.