|
Tue, Aug 7, 12 at 14:05
| Installed new blower motor (4 Speed) in a Payne Furnace. Works fine with the connection of the white wire to white wire, black to black. I also have a red wire connected to the printed circut board at a location marked low. I was about to connect this to the red wire on the motor, but found with a volt meter that when the fan is running on high (black wire) the red wire as well as the yellow and orange wires ,different speeds, all show approx 150 volts coming from them. i am reluctant to connect the red wire to the circut board in fear of frying the board.
Any info. out there |
Follow-Up Postings:
Post a Follow-UpPlease Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Heating & Air Conditioning Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.