|
Fri, Dec 11, 09 at 22:06
| I have a Sears garage door opener with the large button on top, with the smaller "light" and "lock" buttons underneath. Recently, the unit has started intermittantly stopped working unless I press the "lock" button first, then press the open/close button. I have tried holding the "lock" button to reset it, but it still occurs. I purchased a replacement panel from Sears and installed it, but the problem still exists. The remotes work fine, along with the keypad.?????
I am thinking that the IC board is defective, in which case I'll probably replace the unit. Does anyone have any words of wisdom before I do so? Thanks, Cappy |
Follow-Up Postings:
|
- Posted by don_1_2006 (My Page) on Mon, Dec 14, 09 at 9:47
| I would make sure all the connections are tight. Check the two connections on the rear of the wall control. If they check out I think you would be ahead to replace that unit. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Garages/Workshops Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.