|
| Sorry to post yet another message about the craftsman 1/2 HP garage doors, but I have searched through the many posts and while some of the suggestions helped me some, I still can't solve my problem.
I have 2 Craftsman 1/2 HP Model number 139.53515SR garage door openers (They came with the house I recently purchased). Through the help of this forum, I have been able to program the remote to the 1 garage door opener, but I cannot for the life of me get the second garage door opener to work with that remote, or a second one, of the same model number, which I purchased. I have tried holding in the "learn" button, sometimes for as long as a full minute to attempt to reset it. Then pushed it once, and held the button on the remote, to no avail. Is there something else I can do to try and get the opener to work? I'd really hate to replace the opener, it works just fine with the hard wired button on the wall, so the motor and everything else is fine. I just can't get it to work with the remote. Thanks in advance for your help! |
Follow-Up Postings:
|
- Posted by don_1_2006 (My Page) on Sat, Dec 1, 07 at 17:57
| If you can't get the opener to program using your known good remote then your logic board is bad. |
|
| Ok, me being a novice to this sort of stuff - how do I replace / fix the logic board? Thanks in advance for your help! |
|
- Posted by don_1_2006 (My Page) on Tue, Dec 4, 07 at 12:50
| You are not going to be able to repair the logic board. It is replace only. It is the end of your opener where all those white wire go. If you had a new one in your hands you would know what was involved. They cost around $80.00. |
|
| Ok thanks for the help, I guess I'll give that a shot. |
|
| I too have been having programming problems. I am trying to program the control built into my car. I tried using the learn button. Didn't work. My note about the Premium Control Console says it "Can be used to program the opener to accept additional remotes." It doesn't say how. Does anyone know? Thanks, Eddie |
|
- Posted by steve lee(sjtulirui@yahoo.com.cn) onSun, Apr 3, 11 at 7:13
| if it is a fixed-code model which uses dip switches to set the address pins of encoder and decoder ic, maybe you should check out the remote control dip switch calculator at solidremote, it will save you a lot of calculations. |
Here is a link that might be useful: remote control dip switch calculator
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Garages/Workshops Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.