Return to the Garages/Workshops Forum | Post a Follow-Up

Craftsman Door opener 139.53413 not recognizing limit settings

Posted by malr (My Page) on
Sun, Dec 6, 09 at 14:30

I am a Craftsman 139.53413 model opener.
It has stopped responding to the up/down limit settings and I am looking for ways to remedy this, or at least test for what part of the process is going haywire.
It stills operates in both directions but will only stop when crunching into the stop bolt in the up position.
I have adjusted both up and down limit screws in both directions and they have no effect on how far the door will travel.

Follow-Up Postings:

RE: Craftsman Door opener 139.53413 not recognizing limit setting

I would suspect a bad logic board. Make sure the gray wire is still connected to the center contact of the limit switch assembly.

 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!

Return to the Garages/Workshops Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.

Learn more about in-text links on this page here