|
Sun, Sep 5, 10 at 17:11
| I have a Genie Screw drive opener that drives past the limit switches (both up and down) and will not stop. Even the force setting does not seem to work since the door basically buckled from the force. The obstacle sensor does work and reverses the door if blocked.
I tried unplugging the opener for a minute to possibly "reset" something internal, but to no avail. Any ideas or is there something "fried" that can not be repaired? |
Follow-Up Postings:
|
- Posted by don_1_2006 (My Page) on Tue, Sep 7, 10 at 10:14
| Make sure you don't have a broken wire going to the limit switches. I would also pull the boards and check for burnt or missing traces on the printed circuits. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Garages/Workshops Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.