|
Mon, Sep 26, 11 at 11:26
| I have a 1/2 hp Craftsman. When I push the remote it will try to close but at various stages 1/4, 1/2 and 3/4 way down it opens and then the light flashes 5 times. I have checked the laser sensors and they seemed to be aligned. One is a steady green and the other is a steady amber. I can close the door by holding the wall button until it is all of the way shut. Please help...I would rather not pay the astronomical fee of getting someone to look at it. |
Follow-Up Postings:
|
- Posted by don_1_2006 (My Page) on Mon, Sep 26, 11 at 11:44
| If when the door reverses to the open position the main light flashes 10 times it is a door sensor problem. Make sure the small light on each sensor are on and not flickering ever so slightly. (check closely) Tweak them a little even though they may seem to be okay. Check for 5vdc between terminals 2 and 3 on the rear of the motor unit. If there is no voltage or if it is greater than 6vdc the logic board is bad. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Garages/Workshops Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.