|
Sat, Sep 15, 07 at 6:49
| Worked great until we were required by code to sheetrock our garage...
Now it wont go down without you holding the button that normally you touch once and the door opens or closes. Release button and it reverses with flashing light. Seems to me that by holding the button we are perhaps overriding a safety switch I now have one sensor that flickers. Even when realigned it flickers. Guessing that the sensor has gone bad. Suggestions? |
Follow-Up Postings:
|
- Posted by akachrisinmass (My Page) on Sat, Sep 15, 07 at 10:40
| Problem solved after checking all the wiring for damage etc etc. The receiver sensor had been knocked out of vertical alignment. I'd only checked the horizontal alignment. Problem solved best of all at no cost |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Garages/Workshops Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.