|
Fri, Aug 27, 10 at 11:42
| I am having problems with a Sears 1/2hp garage door opener model 139.53636srt. To close it you have to hold the inside control button in until it closes all the way. I replaced the sensors, and they are both lit and appear to work fine. I also checked all control and sensor wiring for faults and correct installation. The green led on the lift unit blinks 4 times and pause, repeat. The door will not close by remote, breaking the beam with the door open will not turn on the light, and one push of the control button will not close the door. Any ideas on what I should do next? I have a really big hammer... |
Follow-Up Postings:
|
- Posted by don_1_2006 (My Page) on Fri, Aug 27, 10 at 17:01
| The blinking LED is sending the code for: Safety reversing sensors slightly misaligned (dim or flashing LED). |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Garages/Workshops Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.