|
Thu, Jul 20, 06 at 18:29
| My mom has a craftsman garage door opener model#139.53635srt. The bearings in the gear and sprocket assy. went bad. I installed a new assy.. However I seem to have an adjustment problem I think. I can get the door to come up but I cannot get it to go down. When I try to get it to go down I think it makes a clicking noise then the motor just buzzes |
Follow-Up Postings:
|
| Is the trolley (the thing the door and the chain is attached to) jammed against the bolt in front of the motor unit. If so, remove the bolt, turn the 'up limit' on the side of the unit about 3 turns in the opposite direction of the arrow printed on the cover. If it operates okay then replace the bolt. |
|
| Thanks for the suggestion but it didn't seem to help. I noticed that the l.e.d.'s on the safety sensors down by the floor of the door are not lit. I will try checking for voltage at the sensors. If ther is does this mean the sensors are misaligned or faulty. If no voltage then maybe a board issue? |
|
| If the small light is not lit on both of them check the wiring to the motor unit. If one is lit and the other is not make sure they are pointed directly at one another. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Garages/Workshops Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.