|
Fri, May 23, 08 at 15:54
| I've got an older 1/2hp chain drive Craftsman garage door opener. Yesterday it started acting up. The wall switch was activated and the door went half way down and then stopped. I reset power to the opener and got it to go down using a remote switch. Now it will go up and down with a remote, but it will start going up or down by itself and will not operate at all using the wall switch. Has anybody seen this?. Also does anybody have a pinout and/or voltage chart for the wall switch? |
Follow-Up Postings:
|
- Posted by don_1_2006 (My Page) on Fri, May 23, 08 at 16:22
| Sounds like the wall control is bad. Try disconnecting it and see if your problems don't stop. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Garages/Workshops Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.