Return to the Garages/Workshops Forum | Post a Follow-Up

 o
Craftsman Garage door opener will not open garage door

Posted by suem56 (My Page) on
Mon, May 5, 08 at 0:48

I have a Craftsman garage door opener #139.53681B. The opener just stopped opening the garage door so I replaced the battery (thinking the battery was dead) & now it will not work. I had a 2nd garage door opener which no longer will open the door. I thought maybe it might have lost it's memory, so I tried to reset it following the instructions on the back of the receiver but it still will not open the garage door. The garage door will, however, open with the wall switch. Any ideas on how I can get this to work again? It is very annoying as I now have to pull out of the garage, turn off the car, go into the garage & close the door with the wall switch, go out the front door & lock that & get back in the car. Anything you can tell me to do that might help would be greatly appreciated--thanks!


Follow-Up Postings:

 o
RE: Craftsman Garage door opener will not open garage door

It's a little confusing but did your remote quit working when you tried to program the other? Try programming them again and see if one works. If neither works I think your receiver has quit working. This is part of the logic board.


 o
RE: Craftsman Garage door opener will not open garage door

sorry to be confusing--the first door opener quit working after I replaced the battery. I had a second opener which also quit after replacing the battery. I now have two openers that no longer work. If your theory is correct, can you advise how to fix it? Thank you!


 o
RE: Craftsman Garage door opener will not open garage door

The logic board is the end of the opener where all those white wires go. It normally has the part number stamped on it and begins with 41A. It is also fairly expensive. Some batteries can be put in backward. Make sure this is not the case.


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Garages/Workshops Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here