Genie Model 404 GDO question
Landers3
11 years ago
More Discussions
It operates normally, after I cleaned the upper & lower limit switches, but there's a wire disconnected inside the drive unit. I think the wire should connect a Torque Sensing switch at the rear of the shaft, to the sequencer board. There's what looks to be a diode coming from the board, with one loose end that might be where the wire should go. I really don't want to chance blowing the board by experimenting. Does anyone know for sure about this wire? Thanks.
bus_driver
Landers3Original Author
Related Professionals
Fountain Hills Interior Designers & Decorators · Middle Island Interior Designers & Decorators · Ridgefield Park Interior Designers & Decorators · Stanford Interior Designers & Decorators · Casas Adobes Cabinets & Cabinetry · Brea Cabinets & Cabinetry · Crestview Cabinets & Cabinetry · Farmers Branch Cabinets & Cabinetry · Holt Cabinets & Cabinetry · Oakland Park Cabinets & Cabinetry · Roanoke Cabinets & Cabinetry · South Gate Cabinets & Cabinetry · Spring Valley Cabinets & Cabinetry · Sunset Cabinets & Cabinetry · Wadsworth Cabinets & Cabinetry