Return to the Garages/Workshops Forum
| Post a Follow-Up
garage door opener problem
| | |
Posted by
tomok1 (
My Page) on
Fri, Mar 20, 09 at 12:45
I have a 10 year old Lift Master with the safety beam system.
Both green lights on the sender and receiver ore lit but the safety beam does not work.
Door works otherwise.
Before replacing the sensors could the problem be the main PC board. Any suggestions?
Thanks |
Follow-Up Postings:
RE: garage door opener problem
| | |
| You are correct it could be a logic board problem. But what is it your sensors are doing or not doing? |
RE: garage door opener problem
| | |
| Both green lights stay on even when the sensors are not lined up. The door still operates both up and down even when the beam is broken |
RE: garage door opener problem
| | |
| Very unusual symptom. I would sure say a logic board and your safety feature is gone. |
RE: garage door opener problem
| | |
Any other way to check for logic board before I get new one.
Best place to get parts?? |
RE: garage door opener problem
| | |
| I don't know of a test other than replacement. Sears or any good door opener service company should have them. Some people deal with e-bay but I personally don't. |
RE: garage door opener problem
| | |
For everyons info the problem was the receiving sensor.
My neighbor had same system so I tried his and it was it.
Thanks for the help. |
RE: garage door opener problem
| | |
| Hello My concern is the garage door is binding when the door is being closed. It stop a few feet and goes back up. I've cleaned the eye sensors and still a problem. What next please. |
RE: garage door opener problem
| | |
| If the door is binding you don't have a door opener problem. Release the door from the opener and find out what is binding. |
Post a Follow-Up
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in.
If you aren't yet a member, join now!
Return to the Garages/Workshops Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.
