|
Mon, Mar 31, 08 at 12:06
| I hope one of you can help me. I recently replaced the water inlet tube on my power washer it was cracked(plastic) Before I took it apart other than the obvious problem it ran well. there is a tube on it that can be used to suck soap into the water supply for washing cars ect. it only does this on low pressure setting. Since I put it back together the leak is fixed but the water now flows out of the tube designed to suck and of course the pump runs constantly because it senses a water leak(no pressure) It appears to be a water valve problem is there a certain way to put them back together it appears you can put them together three ways. Hope somebody can help. |
Follow-Up Postings:
|
| check manual |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Garages/Workshops Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.