|
Mon, Mar 20, 06 at 11:15
| I'm trying to replace part 41A2817 in a Craftsman garage door opener and I can't get the old roll pins out so I can remove the gear. Any suggestions? |
Follow-Up Postings:
|
| A 1/16 inch punch or a nail with the point filed off will knock out the roll pin. The key is to knock out the roll pin before you remove any other part. Sometimes you will need something to turn the old gear so you can get a clear shot at the roll pin. Hope this helps you. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Garages/Workshops Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.