|
| Hi All
After scanning the forums I could not find a fix to my problem, so I went after it myself and this is what I found. My 1993 1/2 hp Lift Master with PC board #41A4252-7 Model 1255 was intermitantly not going down when open. I check all the stuff suggested by the forum and all check OK. Then I pulled the PC board out and found the connection on the PC board from the big Relay was just barely visiable but was cracked away from its solder joint. Resoldered and now it works great. This board is used in alot of openers if yours is acting up and you hear a clicking but the motor does not start you might want to look at this. |
Follow-Up Postings:
|
- Posted by don_1_2006 (My Page) on Tue, Jan 23, 07 at 14:27
| roddmod you suggestion is great. Vibration is an enemy of printed circuit boards and that board should always be checked for cracks in the traces. It can't always be a simple adjustment. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Garages/Workshops Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.