|
Wed, Jun 2, 10 at 0:29
| I installed a Napolleon BGD34-1NT Fireplace, before I finish the facing I tested the fireplace, I lit the pilot adn then connected the wire ( millivolt wire from fireplace to light the burner)
The burner fires up, but after a few minutes both the burner & pilot goes out. I read a post that dust might be the culprit, from my air compressor I dusted off the dust includign the pilot area. The burner & pilot still goes out after a few minutes.....can anyone offer a hand.... thanks. |
Follow-Up Postings:
Post a Follow-UpPlease Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Fireplaces Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.