|
Sat, Jan 31, 09 at 15:52
| I have a Harmon pc-45 stove and have been experimenting with the dip switch settings on the control panel. This all started when I purchased the Optimizer kit 1-00-06801 to run pellets. This has you adjusting dip switches 1,2,7 and 8 to the on position and 3,4,5 and 6 to the off position. The problem is under these settings I go through a lot of pellets and I seem to get a error, "6 blinking light code" more than usual. I seem to know what switches 1 & 2 do but what do the other switches control? |
Follow-Up Postings:
Post a Follow-UpPlease Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Fireplaces Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.