|
Thu, Aug 25, 05 at 11:04
| A co-worker of mine has a Brother PE150 and she said that she cannot adjust the tension in her bobbin because there is no case and the bobbin just sits down on a spindle. She does not have the manual. I find it hard to believe that a bobbin in any machine would not have a way to adjust the tension. Can you help? |
Follow-Up Postings:
|
| I have a Pe150. Is she threading the bobbin correctly? The directions for threading the bobbin are as follows. 1. Insert the bobbin into the shuttle following the thread direction as noted in the etching under the bobbin cove. 2. Guide the thread end around the finger through the channel toward the back. The channel is on the left hand side. 3. Close the bobbin cover by placing the left end in place and pressing down lightly on the right end to snap in place. There is no need to pull up the lower thread, it is done automatically. According to what I read in my manual all adjustments are made on the upper thread tension. Tell her to contact brother for a manual. |
Please Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Embroidery Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.