Return to the Electronics Forum | Post a Follow-Up

 o
What Can I Do With Ugly TV Cable Cord

Posted by trish-grow (My Page) on
Sun, Nov 11, 07 at 12:11

Dish TV installed in one of our bedrooms where the outlet for the Tv was half way around the room from where we wanted the TV. Now I have this ugly cord running around the edge of the bedroom floor from the TV outlet on the wall to my Tv. How can I hide it or what are my options? They said they could not install a new outlet (where the TV is ) becasue it would be on a outside wall of the house.


Follow-Up Postings:

 o
RE: What Can I Do With Ugly TV Cable Cord

Go get some kind of wire molding to hide the cable behind. Available at most home improvement stores Home Depot and Lowe's.

Here is a link that might be useful: Like this.


 o
RE: What Can I Do With Ugly TV Cable Cord

Thank you for the site. It is a new home with moulding at the baseboards so I guess I am thinking I would be better off with cable TV than Dish TV. Would I still have cables running around the room?


 o
RE: What Can I Do With Ugly TV Cable Cord

Everything about Dish is bad except for DVR with two TVs.

DVR with two TVs is very, very good.

Unless you want DVR with two TVs go to Direct or cable or the local casino bar.

(OP writes of Dish installation problem. Many of us have had the same problem mention in OP -- and worse.)


 o
RE: What Can I Do With Ugly TV Cable Cord

The fact that the wall is an outside wall should have nothing to do with it. Whoever told you this is probably just too lazy to deal with snaking the line through with insulation. I'd bet if it were their home the line wouldn't be a tripping hazard lying across the floor of the room.

Do you have an attic above this room? A basement below the room?


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Electronics Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here