|
Sat, Jan 31, 09 at 9:58
| Have a small combo tv that has been working fine - since last week it shut off by itself. Now I can turn it on via panel sw or remote and a green LED comes on for a couple of seconds and it then goes off. I opened the back and tried securing a few connectors on the board and in so doing I was able to have the TV on for about 10 minutes so I thought I cured the problem - in so doing I noticed that when I tried to secure(move) a voltage regular attached to a heatsink, the tv would turn off - so I was really sure to have found the problem and so I re-soldered carefully the traces on the board below = I did not replace the regulator since I thought the set stayed on...unfortunately I am back to where I was - now when I turn it on via panel or remote, the LED comes on and after 2 seconds it goes off again consistently. Any help and direction will be appreciated. |
Follow-Up Postings:
Post a Follow-UpPlease Note: Only registered members are able to post messages to this forum. If you are a member, please log in. If you aren't yet a member, join now!
Return to the Electronics Forum
Instructions
- You must be a registered member and logged in to post messages on our forums.
- Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review the contents and make changes.
- After posting your message, you may need to refresh the forum page in order to see it.
- It is illegal to post copyrighted material without the owner's consent.
- HTML codes are allowed in the message field only.
- No advertising is allowed in any of the forums.
- If you would like to practice posting or uploading photos, please visit our Test forum.
- If you need assistance, please Contact Us and we will be happy to help.