Mike, If you are getting an access denied while installing SP2 from the MS CD, which happened to me the other day, go to this MS support page and follow the dirrections to create a svcpack.log & the setupapi.log and it will pinpoint the registry key that is denying access, and they tell you exactly what value to change it to, then it'll install fine. That's if this is your problem: "You receive an "Access is denied" error message when you try to install Windows XP Service Pack 2" "CAUSE These issues may occur when permissions for one or more registry keys are restricted in a way that prevents the update of those registry keys. A failure to update a registry key may cause the Setup program to fail." Here is a link that might be useful: You receive an

microsoft codecs for wmp9 and better There's also another codec pack for media player 6.4, and another for something else ... basicly if you have a corrupt codec or are missing the one the camera uses strange things can happen if the web page isnt coded to send your to where-ever and have media player get you the proper codec.

I noticed that it fills at a trickle on cold and warm. Check the hot and cold flow (separately) via diagnostics. If water flow is weak then either 1) the respective valve is bad, or 2) a debris screen is clogged in the hose connection port on the valve or at the supply faucet (if screens are there). I ran the diagnostic and got an error code of 52 -diverter valve error. Fault 52 is caused by water draining (when it shouldn't) during the Eco Active recirculation phase which triggers refilling to compensate ... OR can be related to the fill rate being excessively slow causing a water level top-up to take longer than expected ... which goes back to your first point. It's normal for one water level top-up to occur during Eco Active.

@HU-800120566 Next step is do not try running the machine any further with a bad pump unless you have confirmed there's a fuse on the pump wires in the console, and even then it's not a good idea. The next step beyond that is disconnect the wires from the pump and 1) check for 7 ohms resistance reading on the pump and 2) check for 120v power at the pump wires when running it in diagnostics. If no power at the wires then the motor board is bad. If the resistance reading is more than 10% wrong either + or - then the pump is bad ... but it could be bad even if the reading isn't too far wrong. A test cord can be rigged to run the pump directly from an outlet. Clearly the pump is bad it it doesn't run that way ... or if it runs but overheats and shuts off. Are you sure you're getting Fault 39? A failed pump typically triggers Fault 37. However, the machine does not monitor pump operation directly. Failure to drain is determined by way of the water level not dropping when it should be doing so ... which is via the water level sensor ... so Fault 39 could also be part of that problem. 36, 37, 38, and 39 can be related to the water level sensor or pressure tube issues.