oh well you have every type of connection on there you could get and you only need ONE! IF you have an HDMI cable that goes from your TV to the DVR player that is it that is all you need disconnect all those other cables! the HDMI is video and audio all in one cable that is the advanatage of HDMI one cable and the highest quality. The other options are only to be used if you are using devices that do not use HDMI. So plug the HDMI cable to either the DVR or the DVD depending on which one you want to use, then use the the red and white RCA jacks on the tv (it does not matter if there is a yellow one beside it that yellow is for video not audio so you will use the red and white only) plug your headphones red and white male cords in to those red and white female out jacks on the tv. That is all! leave all other cords out of the equation. As long as all of your devices that you want to connect to the tv have HDMI use that. IF your tv did not have HDMI then you would use the 3 colored ones yellow white and red that carries video on yellow and right and left audio on the red and white. Ok try that just the HDMI cable and your head phones. BE sure that the source input on the tv is set to HDMI if that is what you will be plugging the DVR or DVD into, if the source input is not selected on the tv you will not be getting the signal. This statement right here is very baffling -a 3-prong (yellow, red & white) from the TV (video out) to the three middle (audio out) jacks on the DVR. you state you are going from tv out to DVR out you can not go from out to out there has to be an IN for anything to work. But you do not need those cables so remove them completely from the equation. HDMI out from DVR to HDMI cable IN on the tv period. Headphones base unit red and white male plugs into the TV red and white female audio out jacks. Period

Model number MS3250 C331 Serial number 78200731 I can get to the tv setup menu by holding in the volumn up and down buttons but didn't see an Aux setup, hope this isn't only on the "lost" remote. Dvd uses the 3 colored wires, red, white, and yellow. Dish uses coax cable, can't swap them around. Will try new colored cables tonight.

They should be. Chances are both the DVD player and the Video Player use both use a Yellow RCA connector for the video signal along with Red & White RCA connectors for Stereo audio. It should be as simple as disconnecting the cables from the back of the video player and plugging them into the back of the DVD player. That being said, you really want to check if the TV has an S-Video connector. This cable would replace the Yellow RCA cable from the DVD player, and would be a significant improvement in picture quality.

adjust until it works Here is a link that might be useful: The Shield Complete Seasons