Return to the Cars Forum | Post a Follow-Up

Flushed radiator; car now gurgles; safe to drive to repair shop?

Posted by virginia7074 (My Page) on
Sun, Apr 23, 06 at 23:20

My regular repair shop flushed the radiator & replaced the coolant and hose on my '01 Bonneville last Thurs. I've driven it 3 times since and now hear a gurgling sound from under the dash.

It starts gurgling as soon as I start it and back out of the garage and then gurgles whenever I accelerate from a stop. I've been keeping my eye on the temp guage and it does seem to heat to 200 very rapidly, but so far has stopped there. From looking around on the web, it sounds like there's air trapped and the system needs to be bled(?)

My question is, is it safe to drive it 5 miles to work tomorrow morning, then drive it 8 miles to the repair shop tomorrow night? (I have bad memories of cars in my past that have overheated.) Thanks!

Follow-Up Postings:

RE: Flushed radiator; car now gurgles; safe to drive to repair sh

The gurgling sound is air bubles rushing through the heater core, and yes, the fill needs to be completed. With the engine cold, check the overflow bottle. The liquid will be its minimum level and should be above the "low" mark on the bottle. If not, add coolant until the bottle is half full or at to sligtly above the cold level mark.

Here's whats supposed to happen. When the coolant heats up, it expands and should burp some some trapped air into the bottle. Then, when the system cools and the coolant shrinks, it draws fluid from the bottle into the cooling system, that is, if there is enough fluid in the bottle to keep the inlet/outlet in the bottom of the bottle covered.

After about 3 thermal cycles, the system should have enough air flushed out. After that, keep an eye on the coolant level in the bottle for the next 3 to 4 trips.

The "sealed" coolant systems on today's cars vary in detail such that no one set of descriptions fit all. However, all sealed systems perform the functions described above. The mechanical details do vary. In some systems, the overflow tank is pressurized to the same level as the engine coolant, while in others, the overflow tank is vented to the atmoshpere.

This is what I'd do. With a cold engine, fill the overflow bottle to or slightly above its "cold" mark. Put the cap back on the overflow bottle. Warm the engine into its operating temperature range, then shut off and let cool. After cooling, refill the bottle. Do this until the liquid high and low level stablizes.

Be very careful! Do not remove the cap of a pressurized bottle if the coolant (engine) is hot. Upon release of pressure, the coolant can flash to steam and geyser about half of the coolant out of the system. You could get scalded, not to mention the ensuing mess. Let it cool until you see the coolant being sucked out of the bottle back into the engine.

Antifreeze can be purchased as full strength, or already diluted half water and half antifreeze. Look carefully at your antifreeze container. Do not dilute the already diluted antifreeze.

RE: Flushed radiator; car now gurgles; safe to drive to repair sh

jem is correct about air bubbles trapped in the heater core making the "gurgling" sound. Most of the time we have to open the heater core hoses and bleed the air out of some cars manually. That is what the shop will have to do in order to get rid of the noise.

For the most part it wont hurt anything, except possibly reduce the heating capacity inside the car, and sound annoying.

RE: Flushed radiator; car now gurgles; safe to drive to repair sh

Thanks so much to both of you for responding. I'm going to check the overflow bottle's level before I leave this morning. Thanks again!

RE: Flushed radiator; car now gurgles; safe to drive to repair sh

I've hit that annoying gurgle and turned on the heater so the valve lets the coolant flow freely thru the heater core to get it filled bubble free after a couple of engine hot/cold cycles.

 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!

Return to the Cars Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.

Learn more about in-text links on this page here