I have a 7yo and me and the wife both work full time. I was a gas grill guy my whole life. Im about to build an ODK and got a primo to try out because i heard so much about them. I absolutely love it and so does the wife. With that said it takes a little more effort to get it going but what I do is make sure the grill is prepped before hand....clean and loaded. Then when I am going to grill I usually light the pit then prep the food...but the time the food is ready the grill is too. I do a lot of indirect heat then sear so I dont get the temps too high at first but it can if I need it too. I love the primo so much im going to have 2 in my odk vs a primo and a gasser. Now I will have more room for bigger bbqs...can have different temps for different style cooking...or indirect smoke on one full primo then sear on the other.

I kept my trusty Weber for about a year when I bough mine, and it quickly became a charcoal storage unit. Things that the egg-shaped cookers do "better" than a kettle or gas grill, are, in my biased opinion, and in no particular order: * High temperature sear -- I can easily get the coals to a yellow-orange temperature. It is hot enough that the stainless-steel grill "self cleans" and I get a beautifully marked and seared steak. * Capacity -- I can easily get a 25# turkey *and* four full slabs of ribs into mine (equivalent of a 22 1/2" Weber grill size) * Temperature control -- with the top and bottom dampers, I can much more easily control fire temperature than I ever could on a charcoal kettle. I can be at 700 deg (dome) temperature and shut it down to a 400 deg "dwell" in a minute or two -- basically puts the fire out and cooks using the heat stored in the dome (this also means that unused charcoal is not consumed) -- see warning below * Cook pizza -- Real pizza. 700 deg isn't at all hard to obtain and maintain. * No cover needed -- It's pool tile. Hose it off with the pressure sprayer from time to time. Disadvantages -- its harder to have a "hot" side and a "cold" side. It is clearly cooler around the edges when using it as a grill and I generally deal with it that way. WARNING -- Get yourself a good set of mitts and a ideally a fire-resistant apron, and always, always look away when opening any charcoal-fired cooker of any sort that has been "shut down" in this manner. The high temperatures that remain can "vaporize" all kinds of combustibles, that basically burst into flame when the oxygen rushes in when you open the top. Think turning on the gas in the oven and then tossing in a match. It has never happened to me, but I'd hate to find out that I lost the roll of the dice. Here is a link that might be useful: Cooker Flashback

Posted by trevorlawson I think its fair to say that the CC will out cook a thermadore due to open burners. Fair to say based on what? Please describe what this means. The high end is 22K BTUs-pretty close to Capital. This is the rating for the heat output, nothing to do with open or closed. The low end is 375 BTUs. We don't know what Capital has for that. I am sure everyone knows what I sell. What I sell does not detract from the fact that open burners outperform sealed burners. The difference between open and sealed burners is significant nothing nominal about it. We tested a wolf range with caps on and caps off using same pan same water side by side at the same time, the burner with caps off boiled water over 23% fast..... that is significant Here is the video. Outperform would be a mischaracterization of this "test". I see performance as more multidimensional than putting the most heat in the center of a pan. If you had a wider pan, or changed the metal it was made of, or what you are cooking, your results would be different. This falls under the category of showmanship rather than anything scientific. How can you say this-"the burner with caps off boiled water over 23% fast."without any supporting data? You are right it is not how big the burners are but how the burner delivers heat to the CENTER of the pan, so the base of the pan gets evenly hot. Sealed burner send vast majority of the heat to the outside of the pan, open burners send the heat to the center of the pan. Please explain using the principals of heat transfer how delivering heat to the center of a pan is allowing the base of the pan to get evenly hot. If you have a ring of heat on the bottom of the pan, heat will travel in both directions from that ring to heat the pan. The center will receive heat from more directions and heat quicker, until it comes to equilibrium, than the outside so it is optimum to have a ring with the maximum heat more towards the outside of the pan than the inside. It is much harder to get heat to the part of the pan outside of the ring. A sealed ring burner flame pattern is only slightly wider than an open ring burner, a little more if you have it wide open. If you use a pan with reasonably good heat transfer like copper or aluminum, the burner shape doesn't really matter as much, but I wouldn't want the heat in the middle of the pan. The only way I would see heat in the middle of a pan as a benefit is if I were using a very small pan or a wok. I use everything from a 7 inch pan to make caramel with no stirring to a 14 inch aluminum pan on my sealed burners. For any pan less than 7 inches, I have a "small pan burner" I can make fried potatoes in that 14 inch pan with even color all the way across. I use cast iron if I need a lot of heat as in searing meat.

We went to a couple of barbeque places today and ending up buying the extra large Big Green Egg, and I think we will be very happy with it. Kevin thinks it will be great for parties, and now it will be even easier for us to cook for a crowd. Since we now have three charcoal grills, we can use separate grills for separate dishes which will make it easier for us to make multiple dishes at once, even if they require different temperatures. We also have the electric smoker, and I have to say that we get a more intense smoke flavor from that than we do from the charcoal - or at least it permeates the meat more. For smoking chilies, only the charcoal will do the job the way I want it. The BGE that we bought also has a pizza stone and can be used for grilling pizza - something that I've been wanting to do since first visiting the pizza making forum. We bought some outdoor lights for our pergola, and I think they will provide way more light than we required, but at least we can lower the wattage when we want to. I haven't bought anything for lighting the fountain yet because I want to have that installed by an electrician on an exterior wall of the house. I'm hoping to light much of the back yard that way and have it on a dimmer. I don't really want underwater lights in my fountain at this point but will talk with the electrician about that. I'm thinking that I will get my yard lit in stages and start off with getting some outdoor outlets installed at strategic points so that lights could be hooked up later. We went out for dinner this evening because I wanted sushi! We haven't assembled the Big Green Egg yet. Lars