Return to the Basements Forum | Post a Follow-Up

 o
water problem inside of finished basement wall

Posted by ranger481vs (My Page) on
Sat, Oct 9, 10 at 19:59

I'm fairly certain I have some type of water leak inside a finished wall in my basement. I'm thinking it could be the joint between the wall and the floor. I need to figure out how to take care of this issue, and mainly how do I get at this joint in question. I was planning to remove the bottom 2ft of drywall, but then I have the stud framework that runs along the floor right in front of the joint. Not sure exactly what to do about the framework in order to gain access to the floor joint. Any advice is really appreciated! Thanks, Matt


Follow-Up Postings:

 o
RE: water problem inside of finished basement wall

If you're getting water on the floor that doesn't mean the leak is at the cold joint; it could be anywhere along the wall.

You haven't given any detail. But I would first look at all the obvious culprits on the exterior--reverse grading, broken eavestrough, broken downspouts or downspouts that dump water too close to the foundation. Walk around your house during the next heavy downpour to see where the water is going.


 o
RE: water problem inside of finished basement wall

Downspouts long and okay, gutters okay. Grading was improved, but could probably use a little more grading. I had water that was somewhat puddled underneath the carpet and it seemed to have originated from behind the wall, not coming up from through the cement floor. Need advice on how to get at the wall in order to see if there is a problem with the wall itself. I believe I have mildew issues behind the wall due to a noticeable smell...


 o
RE: water problem inside of finished basement wall

mildew issues behind the wall

From the carpet, too, if it has a rubber backing.

Before tearing off the interior finishing, I'd check for cracks on the exterior, particularly under or radiating from basement windows. It's a lot cheaper in most cases to excavate from the outside than tearing off interior finished walls.

Also, if you have window wells, they could easily be the problem, as most seem not be built with drains to the weepers, that is, if there are weepers.


 o
RE: water problem inside of finished basement wall

Thanks. No cracks that I can see on the outside of the house. No windows on that wall. Carpet and padding has already been pulled back and away form the wall, and condition is good. Mildew is most likely coming from inside wall.Pretty certain I need to open the drywall up and at the very least clean and remove the mildew, etc that is present and check for cracks, etc.

Just need to figure out how to deal with the framework in order to gain access to the floor joint and the rest of the wall. If anyone has advice on this I'd really appreciate it.


 o
RE: water problem inside of finished basement wall

If there's no dehumidification and inadequate insulation, you will get condensation on the foundation walls feeding mould. So it may not be a leak at all. The framing is usually an inch or two away from the wall to make up for irregularities in the wall.

If you end up ripping out a section of wall, don't put it back together the same way. Use appropriate insulation.

Here is a link that might be useful: Building Science Corp. on Basements


 o
RE: water problem inside of finished basement wall

Update:

After doing some more digging (literally), I did find a crack in the foundation wall on the outside of the house, and the location corresponds with the area I had the water issue with in the basement. I spoke with a basement repair guy who quoted $1000 to inject urethane into the crack and then to prevent expanding, add a carbon fiber patch that covers the crack.

The process seems fairly basic. I'm pretty handy, so is this something I could fix myself? If not, any idea if $1000 is a pretty standard price? Seems like a lot for a couple hours work, which does not include fixing the drywall.


 o
RE: water problem inside of finished basement wall

Get some competitive bids. It can also be a DIY repair, but I have no experience with that. See link.

As the link explains, it's also important to see if this is a shrinkage crack or something more serious. The crack repair people working for subdivisions here usually just fill the crack from the inside. Those working for homeowners with finished basements tend to excavate from the outside. After the repair, they cover it with several feet of a Delta-Type membrane. This way, in case the crack expands, water will be kept off the wall.

Here is a link that might be useful: Inspectapedia on Crack Repair


 o
RE: water problem followup

several feet of a Delta-Type membrane

To clarify, they put in a five or six foot width of membrane. If the whole foundation had been originally covered in membrane, chances are the crack wouldn't have leaked in the first place.


 o
RE: water problem inside of finished basement wall

Just yesterday we discovered a wet place on the carpet in our finished basement. Called in a professional right away. Our house is 9 years old. The gentleman checked our whole basement carefully, indicated that his expectation is a crack from the bottom of the window opening and water seeping out from under the drywall. We removed the portion of drywall and insulation under the window, and sure enough, there is a crack, looks like settling, from the window edge to the floor. Drywall was wet for a few inches from the floor. Pulled bak the carpet and used heaters and a fan to dry it up. The man is coming back to use the injection of polyurethane and membrane method to seal it up. Our ground is frozen solid right now but we have had heavy rainfall over the last couple of days. The expert told us he had had 18 calls in the last 24 hours, as the earth cannot absorb the water just now and it runs down between the ground and the foundation, finding any way it can to run, in our case, through a small crack and into the house. In the Spring we will make sure that window well drains are clear, that water is directed further away from the house, that the grading is improved a bit. May dig down by hand to see if anything is required from outside. All the comments here have been incrdibly helpful, as we have had absolutely no experience of this in the past.

Thank you all, and good luck! I may post again after all is said and done to report degree of success.


 o
RE: water problem inside of finished basement wall

Foundation cracks most often develop under and near basement windows as they are stress points. A membrane over an interior epoxy injection serves no purpose.

Photobucket

Epoxy injection into wall crack. Photo: Heather Joy Investments Ltd.


 o Post a Follow-Up

Please Note: Only registered members are able to post messages to this forum.

    If you are a member, please log in.

    If you aren't yet a member, join now!


Return to the Basements Forum

Information about Posting

  • You must be logged in to post a message. Once you are logged in, a posting window will appear at the bottom of the messages. If you are not a member, please register for an account.
  • Please review our Rules of Play before posting.
  • Posting is a two-step process. Once you have composed your message, you will be taken to the preview page. You will then have a chance to review your post, make changes and upload photos.
  • After posting your message, you may need to refresh the forum page in order to see it.
  • Before posting copyrighted material, please read about Copyright and Fair Use.
  • We have a strict no-advertising policy!
  • If you would like to practice posting or uploading photos, please visit our Test forum.
  • If you need assistance, please Contact Us and we will be happy to help.


Learn more about in-text links on this page here